How far should smoke detector be placed from ceiling?

If this is not possible, install the Smoke Alarm at least 4 inches (102 mm) from the wall or corner. For wall mounting (if allowed by building codes), the top edge of Smoke Alarms should be placed between 4 inches (102 mm) and 12 inches (305 mm) from the wall/ceiling line, below typical “dead air” spaces.
A.

Where should a carbon monoxide detector be placed high or low?

In order to ensure that your home has maximum protection, it's important to have a CO detector on every floor. Five feet from the ground. Carbon monoxide detectors can get the best reading of your home's air when they are placed five feet from the ground. Near every sleeping area.
  • Where should I put a carbon monoxide alarm?

    If you live in a multi-story home, be sure to place at least one carbon monoxide detector on each level. If your furnace is located in the basement, be sure to place a CO detector there, as well. Likewise, if you have a gas clothes dryer, put an alarm in the laundry room.
  • What can cause carbon monoxide poisoning?

    Household appliances, such as gas fires, boilers, central heating systems, water heaters, cookers, and open fires which use gas, oil, coal and wood may be possible sources of CO gas. It happens when the fuel does not burn fully. Running a car engine in an enclosed space can cause CO poisoning.
  • What is a carbon monoxide detector used for?

    A carbon monoxide detector or CO detector is a device that detects the presence of the carbon monoxide (CO) gas in order to prevent carbon monoxide poisoning. CO is a colorless, tasteless and odorless compound produced by incomplete combustion of carbon-containing materials.
B.

How many smoke detectors do you need in your home?

This means that if you have a four-bedroom house, and all of the bedrooms are accessed from a second-floor hallway, you need to have a smoke detector in each bedroom and one in the hallway outside the bedrooms. One smoke detector must be present on every floor of the house, including basements and attics.
  • Are smoke detectors required by law?

    This law required ALL residential occupancies to have the required smoke detection devices installed by JULY 1, 1994. In a rented or leased living unit where there are battery powered smoke detectors, the OWNERS must install the smoke detectors.
  • Where is the best place to install a carbon monoxide detector?

    In order to ensure that your home has maximum protection, it's important to have a CO detector on every floor. Five feet from the ground. Carbon monoxide detectors can get the best reading of your home's air when they are placed five feet from the ground. Near every sleeping area.
  • Do you have to have hard wired smoke detectors?

    Homes built before 1992 generally aren't required to have hardwired smoke detectors. However, they still need to have smoke detectors installed, although battery-powered ones are adequate. Homes built in California after 1992 must have hardwired smoke detectors that also have a battery backup.
C.

What is the difference between photoelectric and ionization smoke detector?

One is a “fast flame” fire, the other is for smoldering fires. In tests, ionization alarms will typically respond about 30 to 90 seconds faster to “fast-flame” fires than photoelectric smoke alarms. However, in smoldering fires ionization alarms respond an average of 15 to 50 minutes slower than photoelectric alarms.
  • What does photoelectric mean on a smoke detector?

    A photoelectric type smoke alarm consists of a light emitting diode and a light sensitive sensor located in a sensing chamber. The presence of suspended smoke particles in the chamber scatters the light beam. This scattered light is detected by the light sensitive sensor which sets off the alarm.
  • What are the different types of smoke alarms?

    There are two main types of smoke alarm for home use: ionisation and photoelectric alarms.
    • Ionisation alarms.
    • Photoelectric alarms.
    • Dual sensor alarms.
    • Other types of alarms.
    • Standards Australia certification or ActivFire registration.
    • 10-year battery.
    • Test button.
    • Hush button.
  • What is a photoelectric smoke detector and what is an ionization?

    The two most commonly recognized smoke detection technologies are ionization smoke detection and photoelectric smoke detection. Ionization smoke alarms are generally more responsive to flaming fires. Smoke enters the chamber, reflecting light onto the light sensor; triggering the alarm.

Updated: 16th October 2019

Rate This Answer

5 / 5 based on 3 votes.