Use only distilled water to fill the cells. Distilled water can be purchased at most grocery stores. If the electrolyte levels in the cells are low (plates are exposed), fill each cell to just cover the plates. Then use a battery charger to recharge the battery, or just drive the car for a few days in normal service.
Hereof, what level should you fill your car battery up to?
The fluid level in other batteries should be checked at least once a month and topped up if it drops below the correct level - just above the tops of the battery plates . Never top up with tap water, which contains minerals which may damage the battery.
Which acid is used in a car battery?
Gatorade (powder or liquid), salt, saltwater, baking soda, sea water, or distilled water. A: Anything on your list would have damaged your battery instantly. Battery electrolyte is sulfuric acid and water, and a certain amount of the lead electrolyte in solution.
Distilled water — Distilled water is a type of purified water. It's water that has gone through a rigorous filtration process to strip it not only of contaminants, but any natural minerals as well. Spring water — This is what you often find in bottled water.
Although most car batteries are sealed and maintenance free, they do usually have a water level indicator that will allow you to observe if the water level is good. Low water level means the electrolyte will be out of balance and the battery cells will become too acidic resulting in sulphation on the battery plates.
If you've never tasted steam-distilled water before, you should buy a few jugs at the grocery store to make sure you like it. Steam-distilled water is different because it's completely pure. Most other waters, even “pure spring water,” have a distinct flavor because they contain trace amounts of minerals.
The electrolyte is a chemical medium that allows the flow of electrical charge between the cathode and anode. When a device is connected to a battery — a light bulb or an electric circuit — chemical reactions occur on the electrodes that create a flow of electrical energy to the device.
Method 1 Distill Tap Water with a Glass Bowl
- Fill a 5-gallon (18.927 L) stainless steel pot about halfway full with tap water.
- Place a glass bowl in the water.
- Watch the water collecting in the bowl.
- Create a condensation effect with a hot/cold barrier.
- Boil the water in your pot.
Conventional lead acid batteries contain a liquid that is electrolyte. Which is a mixture of sulfuric acid and water. Under normal conditions a battery loses only water (in the form of vapor, hydrogen and oxygen), and only water should be replaced.
Add coolant as needed. Add the fluid to the overflow tank if your car has one; otherwise, add it to the radiator. (You may want to use a funnel to prevent spillage.) Under most driving conditions, antifreeze should be mixed with distilled water at a one to one ratio, or half antifreeze and half distilled water.
In general, using water as coolant is OK for a short time or as a "get you home" alternative, but it does not have the anti-freeze and corrosion inhibiting properties of a proper coolant mix, so should not be left in the engine for any length of time, especially if you live in a cold climate.
No, you should use distilled water or better yet, de-ionized water. The reason for this is that tap water has minerals that can deform deposits inside the radiator and the cooling system passages of your engine. And over a long period of time they can lead to over-heating.
All cars are designed to work with tap water, even really bad water. So use ANY water if you have to. Distilled water is the only water you should put in your radiator or coolant reservoir, unless it's an emergency. Tap water and even purified water have small amounts of hard minerals in them.
In fact, pure antifreeze will freeze at a temperature not much below where water does. That being said, running straight anti-freeze in very hot climates increases the risk of heat related damage to the motor as the fluid will not as efficiently rid the system of heat.
While water is the best fluid for cooling, it can cause corrosion. Buying an antifreeze that requires you to mix it with water can be a little more involved. However, it gives you more flexibility when it comes to mixture. Generally speaking, a 50/50 mixture of water and antifreeze is a good place to start.
Loosen the reservoir cap just a little, then step back while the pressure releases. Then, remove the cap completely. If the coolant level is low, add the correct coolant to the reservoir (not the radiator itself). You can use diluted coolant by itself, or a 50/50 mixture of concentrated coolant and distilled water.
If there is no overflow tank or if the tank does not empty back into the cooling system, then pour this directly into the radiator, making sure not to go over the “full” line. Warning: Make sure to put the radiator cap back on after adding the new coolant and before starting the engine.
Do not continue to use a vehicle when overheating or with a cooling system leak. Continued driving may cause damage, and adding coolant to a leaking system will not get you very far. Once the engine is cooled, always check coolant levels in both the overflow reservoir or expansion tank (if fitted) and the radiator.
Rather than open the cap on the radiator, just check to see whether the liquid reaches the “Full” line on the side of the coolant reservoir shown here. It's part of the coolant recovery system. If the liquid doesn't reach the “Full” line, open the bottle and add a 50/50 mix of water and coolant until it does.
A blown head gasket can allow your coolant and engine oil to mix. This is dangerous for your engine and can cause a major catastrophic failure. Over time, your hoses get hard and brittle, and as a result, coolant can sometimes leak out where they join with your water pump, heater core, radiator or engine.
Overall, you could pay $400 or more for this repair. Replacing a radiator hose is a quick and easy fix and will only run you $35 to $65 for the entire repair. A radiator replacement cost around $300 or more, depending on the size and type of your car. Don't delay when you find a coolant leak.